Altigen MAXCS 7.0 Update 1 MultiVOIP Configuration Manual de usuario descargar pdf (Pagina 15)

MAXCS 7.0 Update 1MultiVoIP Configuration Guide Page 15 of 27

• Set Caller ID Type to BellCore

• Check the Caller ID Enable check box

4. Select Configuration > Interface.

5. Click the Supervision button and set the following parameters:

• Check the Answer Delay checkbox

• Set Answer Delay Timer to 1

6. These settings only apply to Channel 3. Apply these setting to other FXO channels, if there are

others.

7. Select Save Setup > Save & Reboot, click OK. Wait for the gateway to reboot itself.

Verification

1. Follow Figure 2 and attach the PSTN line 510-252-0001 to FXO/FXS Channel 3 behind the MVP

gateway.

Important! Attach the line to FXS/FXO port instead of the E&M port.

2. Place a PSTN call from an outside line (for instance, from your cell phone) to 510-252-0001. The

call should be sent to MaxCS through the MVP gateway.

3. Apply the same settings to Channel 4 on the MVP gateway. Attach the PSTN line 510-252-0002 to

FXO/FXS Channel 4 behind the gateway.

SIP-Tie Trunk Configuration for Outgoing Calls to PSTN

Before configuring these SIP-tie trunks, the requirements in the section Requirements must be met, and

the steps in the section

SIP-Tie Trunk Configuration for Incoming Calls from PSTN must to be completed.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 26 27

Sin comentarios

Altigen MAXCS 7.0 Update 1 MultiVOIP Configuration Manual de usuario Pagina 15