Altigen MAXCS 7.0 Update 1 MultiVOIP Configuration Manual de usuario descargar pdf (Pagina 17)

MAXCS 7.0 Update 1MultiVoIP Configuration Guide Page 17 of 27

5. Log into the MultiVoIP tool.

6. Select Phone Book > Inbound Phone Book and add a new entry with the following parameters:

• Set Remove Prefix to 222

Important! You can pick any prefix, but once the prefix is selected, it cannot be used as an

extension number.

• Set Channel Number to Channel 3

7. Repeat the same settings for FXO port Channel 4. (Apply the settings only for channels

configured as FXO ports instead of FXS ports.)

8. Under Save Setup > Save & Reboot, click OK. Wait for the MVP410 to reboot itself.

Verification

1. Follow Figure 2, and attach a PSTN line 510252001 to FXO/FXS channel 3 behind the MVP

gateway.

Note: Attach the line to an FXS/FXO port instead of E&M port.

2. Pick up extension 104 (as illustrated in Figure 2) and dial “IP trunk access code” + “IP Dialing

Table Entry ID” + “222” + “14081231234” + “#”.

In this example, the number to dial is 8 1 222 14081231234#.

If “#” is not dialed, the call will still be sent out after a few seconds

Advanced Configuration

Before configuring these SIP-tie trunks, the requirements in the section Requirements must be met, and

the steps in the sections

SIP-Tie Trunk Configuration for Incoming Calls from PSTN and SIP-tie Trunk

Configuration for Outgoing Calls to PSTN must be completed.

Analog extensions behind the MVP gateway are optional. If the analog extensions are required, complete

the steps in the section

SIP Extension Configuration before you proceed.

In addition, make sure you already can make calls among phones, the MVP gateway, and MaxCS without

any problems.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 26 27

Sin comentarios

Altigen MAXCS 7.0 Update 1 MultiVOIP Configuration Manual de usuario Pagina 17