Altigen MultiSite Configurator Manual de instalación descargar pdf (Pagina 193)

100

101

Configuring the Triton T1/PRI Board

164 AltiWare OE System Installation & Administration Manual

T1 Clocking

Depending on the configuration of the T1 boards and span for your

AltiServ system(s), the System Clock Master setup should be set

according to the follow conditions:

• If all of the T1 boards are connected to an FXO (Foreign Exchange

Office) or CO, the System Clock Master check box must NOT be

checked for any of the T1 boards.

• If two AltiServ systems are connected back-to-back with a T1 span,

the System Clock Master check box must be checked for only one of

the T1 boards.

• If two T1 boards in the same AltiServ system are connected back-to-

back with a T1 span, the System Clock Master check box must be

checked for the T1 board that has not been designated by the MVIP

setting as the system’s master clock to drive the MVIP bus.

• If four T1 boards are in the same AltiServ system, where each pair is

connected back-to-back with a T1 span:

—TheSystem Clock Master check box must be checked for one of

the T1 boards from the first pair, that has not been designated by the

MVIP setting as the system’s master clock to drive the MVIP bus.

— The other two T1 boards of the second pair must have its System

Clock Master check box unchecked

Important: In all back-to-back cases, the MVIP Clock Configuration

should be set to “Manual,” and the board connected to the

board configured as the back-to-back clock master must be

designated at the MVIP bus master.

1 2 ... 188 189 190 191 192 193 194 195 196 197 198 ... 454 455

Comentarios a estos manuales

Sin comentarios

Altigen MultiSite Configurator Manual de instalación Pagina 193

Comentarios a estos manuales

Relacionado con productos y manuales para Software Altigen MultiSite Configurator