Altigen MaxReports Manual de usuario descargar pdf (Pagina 212)

Chapter 20: Redundancy Configuration

202 MaxACD Administrator Manual

Step 1: Install the Redundancy Moderator

We recommend that you install the Redundancy Moderator on the same LAN as the

server you will assign as the primary server.

The Redundancy moderator runs as a Windows service.

1. To install the Redundancy Moderator, open the folder Redundancy Mo

derator on the

MaxACD installation CD and run setup.exe in that folder.

2. After you have installed Redundancy Moderator, you

must configure it. Go to the

server where you installed the moderator, and in Windows choose Start > All

Programs > MaxACD Redundancy Moderator > Redundancy Moderator

Configuration Tool.

3. Enter the password (the default password is 22222).

Figure 20-3. Redundancy Moderator dialog box

4. Enter a redundancy key. This key is used to authenticate the connection from the

primary and secondary Softswitches. You must use the same redundancy key on

both the primary and secondary server. The IP addresses of the primary and

secondary server will appear, once the servers connect to the moderator.

5. Choose which server you want as the default active server (primary or secondary),

and the

n click OK.

• If you choose None, the moderator service will reject the querying command

from the Softswitches.

• If the states of the two servers ever fall into conflict, the servers will connect to

the moderator service and check the Default Active Server field to determine

which server should be active.

• When a switchover occurs, the new active server will send a command to the

moderator server to update this field.

When you are ready to change the default password, click Ch

ange Password and

specify a new one.

1 2 ... 207 208 209 210 211 212 213 214 215 216 217 ... 260 261

Sin comentarios

Altigen MaxReports Manual de usuario Pagina 212